Direct cable connection, 3 primary pin

Floating DIRECT & Floating HEADER are two groups of plug-in systems that were developed exclusively for the independent contacting of the wing and fuselage. There are no cables or plugs hanging around that could be damaged or dirty. The male connector is contacted directly with the socket during assembly. This is reliably possible with uniCONNECT, because the socket strips are not rigidly but “floating” connected to the carrier and can therefore move with slight movements and vibrations of the sash. Of course, the system is only suitable for rigidly screwed, right-angled and neatly routed connections. The connector cannot absorb any mechanical stress from an imprecise connector!

The two groups DIRECT and HEADER only differ in connection. DIRECT was primarily developed for reliable soldered connections, HEADER is prepared with normal pins for Uni plugs.
All plugs are screwed together from several high-quality fiberglass elements and can be dismantled and serviced at any time. Each connector is offered in two versions:

RTR   as ready assembled and soldered unit with 2 / 3m cable connected directly 1 to 1. This is installed on one side, the length defined to the servo and assembled with crimp contacts. The remaining cable is laid on the other side to the receiver and assembled there. This finished unit is always delivered in one piece. 1xM and 1xF

DIY   as a kit for the modeler with all parts and screws for the own construction. Thereby attractively prided and always delivered as a pair of 2 pieces, 2xM and 2xF

RTW as a pre-assembled connector to which only the cables have to be soldered - the assembly of the plates is already done. 2xM and 2xF are supplied