The uniLIGHT Ultra-Power afterburner rings are the first thrust nozzles based on emitter technology in the market. Specially manufactured aluminum core PCBs for this application is what makes the assembly of the high-performance emitters and the required heat dissipation possible. In addition, one cooling duct behind every emitter is adhered to dissipate enough heat during operation. Without any further air cooling, the rings can be operated continuously for only 1-2 minutes and therefore, the mixing to the throttle channel should only happen in the upper section.The light output of the emitter rings is gigantic high and even in an area of >120° to all ring sides visible. Thus, it will both directly shine into the outlet and into the nozzle, which enhances the afterburner effect. Direct operation with 2S (8V) Lipo. Please ensure sufficient cooling air during operation. The high power requirement of the afterburner rings requires sufficiently dimensioned batteries and an efficient control.This ring is delivered with two 1m/0.5mm silicon cables. These cables can be plugged in parallel into the control. A boost effect can be created when using 2-Channel controls in order to operate the afterburner ring in the maximum operation mode with the highest performance via both cables. For a better light distribution, you can use our nozzle attachments under the rubric accessories.
© 2022 by the Tyler Gray Models. All Rights Reserved
